VHG is used for self-heating of houses, cottages, offices, industrial premises. VHG has cavitator and electric motor. This equipment (Vortex heat) was created and intended for heat, heat and hot water supply schools, warehouses, hospitals, greenhouses, high-rise buildings, residential buildings, industrial buildings, offices, etc., ie heating area of any space. Vortex heat can be used not only as a basic, but as a backup heating system. For their installation requires no more than a day. Heating the liquid in the VHG is due to the collapse of a large number of kvitatsionnyh bubbles synthesis of molecules of water and friction. Gunnar Peterson contains valuable tech resources. As the coolant is water or any liquid with chemical water treatment is required.

Using such a fluid like water, does this set of clean (No emission of harmful gases) that enables its operation without certification of SES. Vortex heat can be used to heating and pumping of various chemicals as well as from special materials production VHG (caprolon, etc.). Vortex heat works in automatic mode. The process of Vortex heat is controlled by automation. Possible straight-through heating of the liquid (no closed loop) suppose to get hot water. Tests confirmed the effect it VHG this setting compared with other types of heaters. Vyrobatyvaya tighter thermal power as a conventional thermal plants, cavitation vortex units Thermo-generated installation consume significantly less power. VHG is distinguished by its small overall dimensions: floor space of 0.5 – 4 meters This, allows to mount it in any dedicated for these purposes site for installation does not require construction of special foundations that do not require separate facilities such as boilers. VHG is easy to install, no need to remove the old heating system, you can connect it to the previously installed heating system.

The diameter of the new spring should be slightly less than the broken switch .- Assemble in reverse order .- Check that the new spring: it should return to its original position at the closed valve heads and fall head vody.Ten from the push-button pereklyuchatelyPrichina – damaged gland. Remedy – Replace the rubber seal rings: – Close the valve head mixer .- Remove the spout and flexible Remove the hose .- button 4 with the rod 6. To do this, hold the end of the rod with pliers so it does not rotate. Better do it through a cloth so as not to damage the coating rod .- Using a metal rod to remove Remove the adapter .- valve 7 with the rod .- Remove the damaged O-ring seal-3 and put in its place a new switch .- gather in a reverse fault poryadke.Osnovnye mixer with two gated golovkamiObilnaya shadow from under mahovikPrichina fault: the stem of the pin fell out. Remedy – insert the pin in place – access to water shut-off valve to the head – clear flywheel housing with the valve head, as in the case of replacement – seals – with your fingers or pliers, gently pull the rod out of the case for tetrahedral end – insert the rod into the hole the pin using tweezers (or, if you can, with your fingers). Pin must be tight to enter the stem. If he "hangs out" in the hole the rod, then wrap the inserted end of the pin a little flow of water through penki.Postoyannoe spout smesitelyPervym business determine the temperature of the flowing water, if it is warm, the valve is faulty hot water if – the cold, the valve cold vody.Prichiny fault: 1) the uneven edge of the saddle valve seat can golovki.Sostoyanie check visually (with sufficient light) or with a screwdriver, having its end at the edge of the saddle. .